I suspect that the summit is sending all "unknown" traffic to its default route (the fortigate). However when the traffic is coming back (ie a ping reply) it gets lost at the fortigate because the route is not there. Can you add a route on the fortigate for the 192.168.110.0/24 network to 172.26.15.254 and see if the ping goes through?

The difference between optional values and default route parameters is that a route parameter with a default value always produces a value—an optional parameter has a value only when a value is provided by the request URL. Route parameters may have constraints that must match the route value bound from the URL. Route with the lowest AD value will be chosen while forwarding the packet. By default static route has two AD values depending on the previous parameter. If you have used next hop neighbor IP address, then the default AD value will be 1. If you have used exit interface, then the default AD value will be 0. This parameter allows us to create You can see that the default route is the first line sending all packets to the 192.168.1.1 Gateway. Remove A Default Gateway. To remove a default route you will need to use the following command, substituting 192.168.1.1 with the IP address of the default route you previously saw # route del default gw 192.168.1.1 Custom route tables. By default, a custom route table is empty and you add routes as needed. When you use the VPC wizard in the console to create a VPC with an internet gateway, the wizard creates a custom route table and adds a route to the internet gateway.

default via 192.168.122.1 dev ens3 is the same as routing table; Add New Default Gateway. As stated previously default gateway is used to send packages in order to transmit to the destination. We can add new default gateway with the ip route add command like below. $ ip route add default via 192.168.1.1 dev ens3. ip route add will add provided

The default route is the special static route which uses the quad zero format: ip route 0. 0. If the packet does not match the particular route in the routing table, it will be routed to a 0.0.0.0 network. The following is a sample route-eth0 file using the network/netmask directives format. The default gateway is 192.168.0.1, interface eth0. The two static routes are for the 10.10.10.0/24 and 172.16.1.0/24 networks.

Custom route tables. By default, a custom route table is empty and you add routes as needed. When you use the VPC wizard in the console to create a VPC with an internet gateway, the wizard creates a custom route table and adds a route to the internet gateway.

The routing is the first configuration that any app needs, and you have learned one of the best approaches to redirect components to the default route even if you have an empty path into the URL. Make sure to use these two approaches in your React app to simplify the routing. The term "Default Route" usually means "ip route 0.0.0.0 0.0.0.0 x.x.x.x" or "default-information originate". And means, if you don't have a "more specific" route, then send it to x.x.x.x, and that router will take care of it. "Default-information originate", is the exact same thing as "ip route", except it's sending it through a routing protocol.